Applying Adeptia Connect v3.0 Patch

Owned by Akash Kumar Jaiswal (Unlicensed)
Last updated: Sept 28, 2019 by Darcy Carrie (Unlicensed)Version comment
1 min read

Adeptia Connect Patch has two components namely Connect Server and Connect Portal. This patch application depends on some pre-conditions of your previous installation type. Version 2.9.3 of Adeptia Connect was released with a single installer, i.e. it enabled the users to install both Server and Portal through a single installer. Whereas for versions 2.9.2 and earlier, JRE and Tomcat were installed. Therefore, steps to apply this patch would vary for a single installation and for the versions installed using v2.9.2 and earlier. 

Important

This patch can be applied only on v2.9.3. If you are using product version 2.9.2 or earlier, you should first upgrade to v2.9.3 before applying this patch.

Patch Application for Single Installer (v2.9.3 Onwards)

If you have installed Adeptia Connect using a single installer then you should apply the patch in following given sequence:

  1. Apply Connect Server v3.0 Patch
  2. Apply Connect Portal v3.0 Patch

Patch Application for Separate Installation of JRE & Tomcat

If you have installed JRE and Tomcat separately, then the steps to apply this patch will be different.

  1. Patch Application for Dedicated JRE & Tomcat

 

Get in touch with Adeptia Support in case of any issues.

Â