/
Configuring Default Monitoring Parameters
Configuring Default Monitoring Parameters
This section describes how you can configure the parameters, which shall be displayed when you use default as matrix flag.
Steps to configure default monitoring parameters
- Go to ../Serverkernel/etc folder.
Open the monitoring-matrix.properties file (see Figure 2).
Figure 2: Default Monitoring Parameters XML page
Change the value if abpm.monitoring.matrix.default.
By default, parameters of memory, repositoryDb, and logDb categories are displayed. To add another category, add the name of category. Names of categories must be separated by comma.
- Save the file and restart the Kernel and WebRunner.
, multiple selections available,
Related content
Enabling Authentication
Enabling Authentication
More like this
Microservice Settings - Webrunner
Microservice Settings - Webrunner
More like this
Monitoring Adeptia Suite Performance
Monitoring Adeptia Suite Performance
More like this
Configuring Load Balancer for Health Checkup
Configuring Load Balancer for Health Checkup
More like this
Properties and Settings
Properties and Settings
More like this
Properties and Settings
Properties and Settings
More like this