Deploying Objects - Linux

You can deploy objects in Adeptia Connect, using Migration utility. You must have an exported zip file to deploy.

Before start deploying, ensure that you have run the Migration utility.

To deploy objects:

1. Type 3 to deploy and press ENTER key.
   
   
   
   

2. Follow the utility to provide the:

   1. Location of the source zip file, and

   2. Location of the Adeptia Connect (till AdeptiaServer directory) on which the zip is to be deployed.

3. Press ENTER key.

   
   
   

4. Type Y to retain objects at the target else type N. If you type Y then you need to provide the location where retain.xml file is stored to retain objects at the target.
5. Press ENTER key.
6. Perform the following actions based on GAC enabled/disabled:

   1. In case GAC is disabled then type Y to select the user ownership.  If you type y then you need to select the user to give ownership of the migrated objects. If you select a user, all the migrated objects will be assigned to the user. In case you don't select, all the users with migrated objects from the source environment will move to the target environment. 

   2. In case GAC is enabled then select the specific user. 
      
      
      
      

      Only IT users will be available to change ownership of the migrated objects.
7. Press ENTER key.
8. The utility starts deploying the objects. A message "Objects successfully deployed" confirms objects have been deployed successfully. In case of failure, it displays an error message and rollbacks the entire operation.